Concrete Countertop

Concrete Countertop Square Edge-57mm

For a sqaure edge - Euroform measurements

Concrete Countertop Square Edge-57mm - Value pack

Z Clips are used to hold alkali resistant fiber glass scrim reinforcing securely at the appropriate height for cast-in-place concrete countertops using Z Counterforms.

Finally a concrete countertop form that is meant for heavy duty commercial bar tops and islands. Instead of the standard 2-1/4" tall appearance from our regular forms

8 Foot self-adhering flexible sink form. Will conform to most undermount sinks. For double bowl sinks, the sink form can be notched with a utility knife to bridge the divider.

One reusable silicone faucet knockout that will create a 1-3/8" hole which will work with most standard faucets. It will also create a 2-1/2" pocket that is 1" beneath the surface to fasten hardware in.

A standard 8' long square edge form (single piece of SE-001 or SE-002) that is factory cut to accommodate a radius as tight as 6".

This package contains twelve 8 foot pieces (96 lineal feet) of reusable Pre-Cast forms, approximately 4 mm thick x 2 " x 1.5". Use these forms to create a mold and cast your countertop off site

For a sqaure edge - Euroform measurements

One reusable silicone faucet knockout that will create a 1-1/4" hole which will work with most standard faucets. It is meant to be used with our thinner EuroForm ONLY and 1/4" substrate.

Double Fancy Radius - 57mm