Numer artykułu:: | FK-001 |
Dostępność: | Na magazynie |
Reusable silicone faucet knockout – 35mm
Will create a 35mm (1 3/8”) hole which will work with most standard faucets. It will also create a 2-1/2" pocket that is 1" beneath the surface to fasten hardware in. This will accept most faucets and spouts.: Must be used with 12,5mm ( ½”) substrate and our standard 57mm (2 ¼”) forms.
If using “EuroForms” profiles, use EuroForm Knockout.
To install, use a 68mm (2 5/8”) hole saw. Push the knockout up through the hole from the underside of the cement fiber board until the 3rd ring hits the bottom of the cement fiber board. Check to make sure the top of the knockout is flush with the top of the forms. For most applications we normally like to split the difference between the sink opening and the backwall so that you have the most concrete possible around the faucet. If you have a deeper countertop or smaller sink, please check to make sure that the faucet is lined up properly over the sink.